Toner Transfer Pcb. Carefully place your artwork face down onto the wet pcb if the paper is not fully damp add drops of transfer solution to the dry bits until it is fully damp. For this you will have to place the printed paper on the clad board with the printed side to the copper as in the image below.
It seems to work pretty ok but it is getting old i want to get new even better printer for toner transfer method. Carefully place your artwork face down onto the wet pcb if the paper is not fully damp add drops of transfer solution to the dry bits until it is fully damp. Ad leading uk printed circuit board manufacturer.
Once one side is transferred i drill a few holes for alignment and pass some needles and then place the second side of the circuit print and transfer that.
Immediate online prototype quotations. I had an irregular copper board as i bought a big plate some time back and used it a couple of times. Carefully place your artwork face down onto the wet pcb if the paper is not fully damp add drops of transfer solution to the dry bits until it is fully damp. Transfer the toner to the copper clad board.